Po pierwsze trzeba kamerę przywrócić do ustawień domyślnych. Włączamy zasilenie, trzymając przycisk z tyłu przez około 15 sekund:
Cytuj:
1. Disconnect the power cable.
2. Press and hold the Control button (rear panel) and reconnect the power cable.
3. Keep the button pressed until the Status Indicator displays yellow (this may take up to 15
seconds), then release the button.
4. When the Status indicator displays green (which can take up to 1 minute) the camera is
reset to the factory default settings.
5. Re-install the AXIS 206 using one of the methods described in this document.
Trzeba jej ustawić adres IP. Nie jest to trywialne, ale z pomocą przychodzi procedura opisana w instrukcji instalacji:
Kod:
arp -s 192.168.0.125 00-40-8c-18-10-00
ping -l 408 -t 192.168.0.125
Adres MAC to oczywiście numer seryjny z tyłu kamerki. Po wydania w/w komend wyłączamy/włączamy zasilanie kamerki.
Kod:
C:\Documents and Settings\bart>arp -s 192.168.0.2 00-40-8c-7f-7a-5f
C:\Documents and Settings\bart>ping -l 408 -t 192.168.0.125
Badanie 192.168.0.125 z użyciem 408 bajtów danych:
Upłynął limit czasu żądania.
Upłynął limit czasu żądania.
Upłynął limit czasu żądania.
Odpowiedź z 192.168.0.2: bajtów=408 czas<1 ms TTL=64
Odpowiedź z 192.168.0.2: bajtów=408 czas<1 ms TTL=64